Geometry Menu; Horizontal Position; Vertical Position; Aspect Ratio - Digital Projection TITAN SX+ 3D, DUAL 3D ULTRA CONTRAST User Manual

For important information about how Input 8 is used, see
TITAN sx+ 3D, Dual 3D, Ultra Contrast
Digital Projection

Geometry menu

To return to the main menu, press
From the main menu:
•
Press and until Geometry is highlighted.
Press to open the Geometry menu. The blue highlight moves to the first item
in the menu.
Input
Picture
Geometry
Colour
Setup
Information

Horizontal Position

•
Press and to select H Position.
Press and to adjust the slider.

Vertical Position

•
Press and to select V Position.
Press and to adjust the slider.

Aspect Ratio

•
Press and to select from:
Fill This will best fit the incoming source to fill either the height or
width without changing the aspect ratio of the source.
User Aspect
1.33:1 (4:3)
1.6:1 (16:10)
1.78:1 (16:9)
2.35:1 (Scope)
1.66:1 (Vista)
1.85 (Flat)
Theaterscope Use with the TheaterScope Anamorphic System only. The
2.35:1 source image is displayed using the full area of the 16:9
DMD. This is then stretched to 2.35:1 by the lens.
Native The image will be displayed pixel for pixel. The image will be
centred, with a black border if smaller than full resolution or
cropped if larger.
Rev C April 2011
up to three times.
H Position 128
V Position
64

Aspect Ratio

User H Aspect 500
User V Aspect
500
Keystone 0
Phase 127
Resolution
Blanking
INPUT 8 in the Notes column
User Manual
1.85:1 (Flat)
, and also Section 4, Overview.
4. Controlling the projector
Notes
Some menu controls can be
accessed directly using the
control keys (see earlier in this
section).
When using the menus, press
OSD or
reveal the On-Screen-Display.

Geometry Menu

None of the Geometry controls
are available for Input 8.
Some menu items may be
greyed out - unavailable due to
the effect of settings made in
other menus, or due to the type
of input signal.
Aspect Ratio selection can be
found in both the Picture and
Geometry menus.
When User Aspect is selected,
the Aspect Ratio settings are
taken from the User H Aspect
and V Aspect settings (see
next page).
WUXGA models only:
The full height of the DMD can
be used only by WUXGA and
UXGA images.
For more information, see
Screen requirements in
section 2. Installation.
to hide or
Page 4.27