Dark Time; Frame Dominance - Digital Projection TITAN SX+ 3D, DUAL 3D ULTRA CONTRAST User Manual

For important information about how Input 8 is used, see
4. Controlling the projector
Setup menu, 3D Setup continued

Dark Time

Ghosting can be caused by the left and right images overlapping during the time
that the Z screen or 3D glasses are switching.
Fully on
Fully off
Dark
time
•
Press and to select Dark Time.
Press and to adjust the slider (0 to 6000 µS).

Frame Dominance

The outgoing 3D frames are in pairs - the dominant frame being presented first.
Dominance Left
LEFT 1 RIGHT 1
Dominance Right
RIGHT 1 LEFT 1
•
Press and to select Frame Dominance
Press and to select from:
Left
Right
Page 4.56
Digital Projection
Right
Left
Dark
time
LEFT 2 RIGHT 2 LEFT 3
RIGHT 2 LEFT 2 RIGHT 3
INPUT 8 in the Notes column
TITAN sx+ 3D, Dual 3D, Ultra Contrast
Dark
time
RIGHT 3
LEFT 3
, and also Section 4, Overview.
User Manual
Notes
3D may not be present on some
models
None of the 3D options are
avialable unless 3D Mode is set
to Consumer or Professional.
In order to achieve maximum
light output and a smooth
greyscale, whilst eliminating
ghosting, the following
procedure is recommended:
1. Set the Dark Time to a value
appropriate to the glasses or
Z-screen, say 1000 µS.
2. Adjust the Sync Delay time
(see next page) to eliminate
ghosting and achieve a smooth
greyscale.
3. Repeat steps 1 and 2 until the
best result is obtained.
Set the frame dominance to
match the incoming 3D video
frame sequence.
Rev C April 2011