Using The Control Keys; Power; Shutter; On-Screen-Display - Digital Projection TITAN SX+ 3D, DUAL 3D ULTRA CONTRAST User Manual

For important information about how Input 8 is used, see
4. Controlling the projector

Using the control keys

Power

•
Press POWER and hold for 3 seconds, to switch the projector ON.
•
Press POWER and hold for 3 seconds, to switch the projector OFF.

Shutter

•
Press SHUTTER
•
Press SHUTTER

On-Screen-Display

•
Press OSD to switch the On-Screen-Display OFF.
This includes ALL menus, controls and on-screen messages.
•
Press OSD to switch the On-Screen-Display ON.

Focus

•
Press followed by
When adjustment is finished, press

Zoom

•
Press followed by
When adjustment is finished, press

Shift

•
Press followed by
right.
When adjustment is finished, press
Page 4.12
Digital Projection
to OPEN the shutter.
to CLOSE the shutter.
and to adjust the focus.
.
and to adjust the zoom.
.
, , or to shift the lens up, down, left or
.
INPUT 8 in the Notes column
TITAN sx+ 3D, Dual 3D, Ultra Contrast
, and also Section 4, Overview.
User Manual
Notes
Closing the shutter produces
a better black than simply
removing the signal, as the
light source will be completely
blocked by the shutter blade.
When the OSD is OFF:
- all menu navigation keys are
disabled.
- keys such as BrI
(brightness) will still function,
but the slider bars will not be
visible on screen.
When any of the three Lens
adjustment keys is pressed, the
blue Transmit indicator on the
remote control will light for 10
seconds:
- after 10 seconds, if no
adjustment has been made,
the indicator will go out and
the Lens adjustment key must
be pressed again to resume
adjustment.
- to end the adjustment before
10 seconds has elapsed, press
the key.
- all other adjustments will
be locked out until the Lens
adjustment is ended.
For more information about the
amount of lens shift available,
see section 2. Installation.
Rev C April 2011