Geometry Menu; Horizontal Position; Vertical Position; Aspect Ratio - Digital Projection TITAN sx+-500 User Manual

4. Controlling the projector

Geometry menu

To return to the main menu, press
From the main menu:
•
Press and until Geometry is highlighted.
Press to open the Geometry menu. The blue highlight moves to the first
item in the menu.
Input
Picture
Geometry
Colour
Setup
Information

Horizontal Position

•
Press and to select H Position.
Press and to adjust the slider.

Vertical Position

•
Press and to select V Position.
Press and to adjust the slider.

Aspect Ratio

Press and to select from:
Fill This will best fit the incoming source to fill either the height or
width without changing the aspect ratio of the source.
User Aspect
1.33:1 (4:3)
1.78:1 (16:9)
2.35:1 (Scope)
1.66:1 (Vista)
1.85 (Flat)
Native The image will be displayed pixel for pixel. The image will be
centred, with a black border if smaller than native resolution or
cropped if larger.
up to three times.
H Position 128
V Position 64
Aspect Ratio
User H Aspect 500
User V Aspect 500
Keystone 0
Phase
127
Resolution
Blanking
Rev C
Digital Projection
1.85:1 (Flat)
March 2008 page 4.24
TITAN sx+-500
User Manual
Notes
Some menu controls can be
accessed directly using the
control keys (see earlier in this
section).
When using the menus, press
OSD or
reveal the On-Screen-Display.
Geometry Menu
Some menu items may be
greyed out - unavailable due to
the effect of settings made in
other menus, or due to the type
of input signal.
Aspect Ratio selection can be
found in both the Picture and
Geometry menus.
When User is selected, the
Aspect Ratio needs to be set in
the User H Aspect and V
Aspect (see next page).
to hide or