Panasonic FP7 User Manual page 29

FP7 Fieldbus Master Units Technical Manual
ErrEvent Explanation
ters.
57 Faulty slave parameter value
in data file.
58 Double slave address.
59 Projected send process data
offset of participant's address
outside allowable range of
0-255.
60 Projected receive process data
offset of participant's address
outside allowable range of
0-255.
61 Slaves' data areas overlapping
for send process data.
62 Slaves' data areas overlapping
for receive process data.
63 Unknown process data hand-
shake.
64 Free RAM exceeded.
65 Faulty slave parameter data
sets.
202 No segment for treatment
free.
212 Faulty reading of database.
213 Structure surrender to operat-
ing system faulty.
220 Software watchdog error.
221 No data acknowledgement in
process data handshake mode
0.
222 Master in auto-clear mode.
225 No further segments.
The following error numbers are valid for the error event if "Error remote
address" is not equal to 255.
ErrEvent Explanation
2 Station reports
overflow.
3 Request function of
master not activat-
ed in the station.
9 No answer even
though slave must
respond.
17 No response from
station.
Source Recommendation
of error
planning
Project Contact technical support.
planning
Project Check projected addresses.
planning
Project Check projected addresses.
planning
Project Check projected addresses.
planning
Project Check projected addresses.
planning
Project Check projected addresses.
planning
Warm Check warm start parame-
start ters.
FMU Contact technical support.
Project Contact technical support.
planning
FMU Contact technical support.
FMU Download database again.
FMU Contact technical support.
Host Check host program.
Host Host program did not
acknowledge the last hand-
shake in time.
Slave Auto-clear mode was acti-
vated because one slave
was missing during runtime.
FMU Contact technical support.
Source of Recommendation
error
Master Check length of configured slave con-
telegram figuration or parameter data.
Master Check slave if PROFIBUS DP norm
telegram compatible..
Slave Check configuration data of the station
and compare it with the physical I/O
data length.
Slave Check bus cable. Check bus address of
slave.
Programming information
29