Symptom: The Scanning Does Not Start. - Fujitsu fi-6130 Cleaning And Maintenance

fi-6130 / fi-6230 Image Scanner Operator's Guide
6.3 Remedying Typical Troubles

Symptom: The scanning does not start.

Back
Did you unlock the transport lock of the
Flatbed? (fi-6230 only)
Are the document loaded correctly on the ADF
paper chute?
Is the ADF closed completely?
Is the interface cable connected correctly?
Is the connector of interface cable broken?
Does the scanning start after running ON the
scanner again?
YES
YES
YES
YES
YES
NO
YES
NO
Turn OFF the scanner and unlock the transport
lock.
(Refer to "2.1 Installing the Scanner in "fi-
NO
6130/fi-6230 Getting Started.")
Load the document correctly on ADF paper
chute.
NO
Remove the document in the ADF paper chute,
open the ADF, and then close it completely.
NO
Connect the interface cable correctly.
(Refer to "2.2 Connecting the Scanner to Your
NO
PC" in "fi-6130/fi-6230 Getting Started.")
Use a new interface cable and correctly
connect it.
The scanner operation is normal.
TROUBLESHOOTING
CONTENTS MAP
TOP