FIGURE 25 Not supported stack trunk cases
NOTE
ICX 7250 stacking trunks should use consecutive ports. For example, 1/2/1, 1/2/2 and 1/2/3, 1/2/4 and
for re-timer ports it is 1/2/5, 1/2/6 and 1/2/7, 1/2/8.
Brocade ICX 7250 Stack Construction Methods
A stack can be built in one of the following two way:
1. Use the 'secure setup' utility to form the stack.
2. Manual stack formation where each unit is configured individually.
Topology
The figure below shows stacking ports and illustrates three units connected in linear and linear
topology. Similarly a stack of up to 12 units can be connected. The example presented here for
configuration is for 12 unit stack.
Please refer to Bill of Materials and the tables below for the software image, optics, and vendor
information.
Brocade ICX 7450, Brocade ICX 7750, and Brocade ICX 7250 Stacking Deployment Guide
53-1003581-03
Brocade ICX 7250 Stack Construction Methods
65