Support; Disassembling The Microscope - Primotech MAT Instruction Manual

7 Maintenance and Disposal | 7.3 Support
Procedure 1
Primotech | Document 430055-9044-008 V.1.0; 03 / 2014

7.3 Support

If you need support, please contact your ZEISS representative or use the following
addresses:
¢
http://microscopy.zeiss.com/microscopy/en_de/website/forms/sales-and-
service-contacts.html
¢
http://microscopy.zeiss.com/microscopy/en_de/service-support/microscopy-
contact.html

7.4 Disassembling the Microscope

If the microscope is not going to be used for a short period of time (days), place
the dust cover over it. If it is not going to be used for a longer period of time,
disassemble and store the microscope.
Press the power switch to turn off the microscope.
2 Remove any samples from the stage.
3 Lower the stage and move it to a central position.
4 Unplug the power supply (plug) and store it in holder on the rear.
5 Unscrew the objective with the lowest magnification and place it in its
protective tube.
6 Screw the dustcap labeled 1 into the nosepiece.
7 Repeat these steps for the other objectives.
8 Remove the eyepieces from the tube and place the protective caps on the
tube.
9 Place the eyepieces in the corresponding protective packaging.
47