Table of Contents
Advertisement
3 First Steps | 3.2 Assembling the Microscope
16
7
Attach the power adapter that is appropriate for your country to the plug.
6
8
Attach the cables between the tube and the rear of the microscope:
– Network cable between the network port of the tube and the top of the
MNA
– 12 V power cable between the power socket of the tube and the rear of
the microscope stand
This does not apply to Primotech D/POL Conoscopy.
9
Plug the microscope into a power socket and press the power switch.
The lowest LED on each side of the stand illuminates.
INFO
Dirt and dust may impair the performance of the microscope. Use the dust cover
to protect the microscope when not in use.
u
Do not place the dust cover over the microscope while the microscope
stand is turned on.
u
Wait 10 minutes for the microscope to cool before placing the dust cover
over the microscope.
7
Primotech | Document 430055-9044-008 V.1.0; 03 / 2014
Advertisement
Table of Contents
