Table of Contents
Advertisement
6 Changing Components | 6.3 Changing the Tube
Inserting Tubes To insert a tube:
Procedure 1
42
Place the tube on the support with the eyepieces pointing to the right.
2
Tilt eyepiece end of the tube upwards so that the dovetail of the mount fits
under the support.
3
Lower the tube so that it is flush with the intermediate tube.
4
Rotate the tube 90° clockwise so that the eyepieces are at the front of the
microscope. Alternatively, rotate the tube 90° counter-clockwise to save space.
5
Use the 2.5 mm hex key to tighten the hexagonal bolt on the right of the tube.
6
Attach the cables between the tube and the rear of the microscope:
– Network cable between the network port of the tube and the top of the
MNA
– 12 V power cable between the power socket of the tube and the rear of
the microscope stand
This does not apply to Primotech D/POL Conoscopy.
Primotech | Document 430055-9044-008 V.1.0; 03 / 2014
Advertisement
Table of Contents
