Connecting Wires To Terminals - Kenwood DDX374BT Instruction Manual

CONNECTION/INSTALLATION CONNECTION/INSTALLATION
Connection
❏ Connecting wires to terminals
10 A fuse
1
See page 66.*
2
See page 66.*
1
White ª / White with black stripe · : To front speaker (left)
Gray ª / Gray with black stripe · : To front speaker (right)
Green ª / Green with black stripe · : To rear speaker (left)
Purple ª / Purple with black stripe · : To rear speaker (right)
Blue (Antenna control wire)
Blue with white stripe (Power control wire)
Brown (Mute control wire)
Light blue with yellow stripe (Steering remote control wire)
Orange with white stripe (Dimmer control wire)
Red (Ignition wire)
Yellow (Battery wire)
Black (Ground wire)
64
See page 66.
Purple with white stripe (Reverse sensor wire)
Light green (Parking sensor wire)
USB terminal (1.0 m): See page 65.
See page 66.
Connect the antenna cord
to the antenna terminal.
3
* Depending on what antenna you are using, connect either to the control
terminal of the motor antenna, or to the power terminal for the booster amplifier
of the film-type antenna. (Max. 300 mA, 12 V)
When using the optional power amplifier, connect to its power control terminal.
Not used.
To use the steering wheel remote control feature, an exclusive remote adapter
(not supplied) matching your car is required.
To car light control switch
1
* Only for DDX374BT/DDX24BT.
* 2
Only for DDX374BT.
3
* If no connections are made, do not let the cable come out from the
tab.
Connect to the vehicle's reverse lamp harness when using
the optional rear view camera.
Connect to the vehicle's parking
brake detection switch harness.
3
• For best safety, be sure to connect
the parking sensor.
Ignition key switch
To car chassis
Fuse box
Battery