Product Specifi Cations - Hitachi C 10RC Instruction Manual And Safety Instructions

PRODUCT SPECIFICATIONS
MOTOR
Type ................................................... Universal
Amps .................................................. 6.5 A
Voltage ............................................... 230-240 V/50 Hz
Watts .................................................. 1430 W (S1)
No load speed .................................... 5000/min
SAW
Table Size with Extension................... 629 mm x 718 mm
Table Extension ................................. Right, Rear
V.................................................. Volts
Hz................................................ hertz
min............................................... minutes
h................................................... hours
I.................................................... ON
/min.............................................. revolutions per minute
Wear safety goggles
Wear ear protection
Wear a breathing mask
●
●
●
● Noise can be a health hazard. When the noise level exceeds 85dB(A), be sure to wear ear protection.
● To avoid electrical hazards, fi re hazards or damage to the table saw, use proper circuit protection. This
table saw is wired at the factory for 230-240 Volt operation. It must be connected to a 230-240 Volt / 6.5
Ampere time delay fuse or circuit breaker. To avoid shock or fi re, replace power cord immediately if it is
worn, cut or damaged in any way. Before using your table saw, it is critical that you read and understand
these safety rules. Failure to follow these rules could result in serious injury to you or damage to the table
saw.
● Through poor conditions of the electrical MAINS, shortly voltage drops can appear when starting the
EQUIPMENT. This can infl uence other equipment (e.g. blinking of a lamp). If the MAINS-IMPEDANCE Zmax <
0.3 OHM, such disturbances are not expected. (In case of need, you may contact your local supply authority
for further information).
SYMBOLS
Riving knife thickness is 2.5 mm.
The maximum radial distance between the riving knife and the toothed rim of the saw
blade is 5 mm.
The tip of the riving knife shall not be lower than 5 mm from the tooth peak.
WARNING
Rip Capacity with Extension...............
Blade Size................................................ 250 mm
Rip Scale ................................................. YES
Rip Fence ................................................ YES
Mitre Gauge ............................................ YES
Maximum Cut Depth @ 90
Maximum Cut Depth @ 45
Net Weight .............................................. 30.14 kg
A......................................... amperes
W........................................ watts
~......................................... alternating current
........................................ class II Construction
O........................................ OFF
– 3 –
English
610 mm Right
0
.................... 73 mm
0
.................... 55 mm