Table Saw Safety - Hitachi C 10RC Instruction Manual And Safety Instructions

1. Do not use saw blades which are High Speed Steel (HS) or damaged or deformed.
2. Replace the table insert when worn.
3. Use only saw blades recommended by the manufacturer which confi rms to EN847-1, with warning that the riving knife
shall not be thicker than the width of the groove cut by the saw blade and not thinner than the body of the saw blade.
4. Select saw blades in relation to the material to be cut.
5. Use push-sticks to feed the workpiece past the saw blade. The push-stick or push block should always be stored with
the machine when not in use.
6. Connect your table saw to a dust collecting device when sawing (Dust chute diameter 58 mm).
7. Use and correct adjustment of the riving knife.
8. Use and correct adjustment of the upper saw blade guard.
9. Wear ear protection.
10. Always take care when slotting, saw shall not be used for slotting.
11. Not for cutting metal, timber or round log.

TABLE SAW SAFETY

– 5 –
English