Product Specifi Cations - Hitachi CB 13F Instruction Manual And Safety Instructions

Some dust created by power sanding, sawing, grinding, drilling and other construction activities contains
chemicals known to the state of California to cause cancer, birth defects or other reproductive harm. Some
examples of these chemicals are:
• Lead based paints
• Crystalline silica from bricks, cement and other masonry products
• Arsenic and chromium from chemically treated lumber
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your
exposure to these chemicals, work in a well-ventilated area and work with approved safety equipment, such
as dust masks that are specially designed to fi lter out microscopic particles.
PRODUCT SPECIFICATIONS
MOTOR
Amps 3.5A
Voltage 230~240V
Hz 50
Watts 760W
Speeds Low................... 6 m/s
High.................. 11.7 m/s
DRIVE BELT................. A 26
Cutting Capacity
Throat.......................... 12" (305mm)
Height.......................... 5" (127mm)
To avoid electrical hazards, fi re hazards or damage to the band saw, use proper circuit protection.
This band saw is wired at the factory for 230-240 Volt operation. It must be connected to a 230-240 Volt / 3.5
Ampere time delay fuse or circuit breaker. To avoid shock or fi re, replace power cord immediately if it is worn,
cut or damaged in any way.Before using your band saw, it is critical that you read and understand these safety
rules. Failure to follow these rules could result in serious injury to you or damage to the band saw.
WARNING
Blade
Width.......................... 1/8" (3.2mm), 1/4" (6.4mm),
Length ........................ 80" (203.2cm)
Table
Size............................ 13" (330mm) x 13" (330mm)
Tilt............................... 0° Left –– 45° Right
Dust Collection............ YES
NET WEIGHT.............. 147.5 lbs (67kg)
WARNING
– 3 –
3/8" (9.5mm), 1/2" (12.7mm)
English