Product Specifi Cations - Hitachi C12RA Instruction Manual

Some dust created by power sanding, sawing, grinding, drilling and other construction activities contains
chemicals (known to the State of California) to cause cancer, birth defects or other reproductive harm. Some
examples of these chemicals are:
● Lead based paints
● Crystalline silica from bricks, cement and other masonry products
● Arsenic and chromium from chemically treated lumber
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your
exposure to these chemicals, work in a well-ventilated area and work with approved safety equipment, such as
dust masks that are specially designed to fi lter out microscopic particles.
PRODUCT SPECIFICATIONS
MOTOR
Type ........................................ Induction
Amps ....................................... 2.6 A
Voltage .................................... 230V/50Hz
Watts ....................................... 2000W (S6, 20%,10min) Maximum Cut Depth @ 45º .............. 55mm
No load speed ......................... 2850min
SYMBOLS
V.............................................. volts
Hz............................................ hertz
min.......................................... minutes
h.............................................. hours
I............................................... ON
min ........................................ revolutions per minute
-1
The noise level of this machine during cutting are as follows:
Sound pressure level: 102.9 db
Sound power level: 116.1 db
Wear safety goggles
Wear ear protection
Wear a breathing mask
Noise can be a health hazard. When the noise level exceeds 85dB(A), be sure to wear ear protection.
To avoid electrical hazards, fi re hazards or damage to the table saw, use proper circuit protection.
This table saw is wired at the factory for 230 Volt operation. It must be connected to a 230 Volt / 7.5 Ampere
time delay fuse or circuit breaker. To avoid shock or fi re, replace power cord immediately if it is worn, cut or
damaged in any way.Before using your table saw, it is critical that you read and understand these safety rules.
Failure to follow these rules could result in serious injury to you or damage to the table saw.
WARNING
SAW
Table Extension ................................ Right or Rear
Blade Size......................................... 315mm
Maximum Cut Depth @ 90º .............. 85mm
Net Weight ........................................ 42kg
-1
A.............................................................. amperes
W............................................................. watts
~.............................................................. alternating current
............................................................ Class II Construction .......................................... ..........................................
O.............................................................. OFF
ENVIRONMENTAL PROTECTION
Recycle unwanted materials instead of disposing of them
as waste. All tools, hoses and packaging should be sorted,
taken to the local recycling centre and disposed of in an
environmentally safe way.
WARNING
WARNING
– 3 –
English