Product Specifications - Hitachi C 10FL Instruction Manual And Safety Instructions

Some dust created by power sanding, sawing, grinding, drilling and other construction activities contains
chemicals (known to the State of California) to cause cancer, birth defects or other reproductive harm. Some
examples of these chemicals are:
• Lead based paints
• Crystalline silica from bricks, cement and other masonry products
• Arsenic and chromium from chemically treated lumber
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your
exposure to these chemicals, work in a well-ventilated area and work with approved safety equipment, such as
dust masks that are specially designed to filter out microscopic particles.

PRODUCT SPECIFICATIONS

MOTOR
Type ................................................... Induction
Amps ................................................. 7.5A
Voltage .............................................. 230-240V/50Hz
Watts ................................................. 1600W
No load speed..................................... 2850/min
Overload Protection ........................... YES
To avoid electrical hazards, fire hazards or damage to the table saw, use proper circuit protection.
This table saw is wired at the factory for 230-240 Volt operation. It must be connected to a 230-240 Volt / 7.5
Ampere time delay fuse or circuit breaker. To avoid shock or fire, replace power cord immediately if it is worn,
cut or damaged in any way.Before using your table saw, it is critical that you read and understand these safety
rules. Failure to follow these rules could result in serious injury to you or damage to the table saw.
Through poor conditions of the electrical MAINS, shortly voltage drops can appear when starting the
EQUIPMENT. This can influence other equipment (e.g. blinking of a lamp). If the MAINS-IMPEDANCE Zmax <
0.29 OHM, such disturbances are not expected. (In case of need, you may contact your local supply authority
for further information).
WARNING
SAW
Table Size with Extensions .......... 27-1/8" x 40-15/32"
Table Extension ........................... Right & Left
Rip Capacity with Extension ......... 24" (610mm) Right & Left
Blade Size .................................... 10" (255mm)
Rip Scale ...................................... YES
Rip Fence ..................................... YES
Miter Gauge ................................. YES
Maximum Cut Depth @ 90º .......... 3-3/8" (86mm)
Maximum Cut Depth @ 45º .......... 2-1/4" (57mm)
Maximum Dado Cut Width ........... 13/16" (20.6mm)
Net Weight ................................... 242.5 lbs (110kg)
WARNING
WARNING
– 3 –
English
(688mm x 1028mm)