Fig. M
2
1
5
4
3
6
INSTALLING TABLE SIDE EXTENSION (FIG. N)
1. Identify the right hand table extension.
NOTE: The right hand table extension is the one with
the measuring scale (1) visible from the front of the
saw when it is installed to the right hand side of the
saw table.
2. Open both front and rear cam locking levers (2) on
the right hand side of the saw base by pulling them
out from the cam locking assemblies (4).
3. Insert the table extension mounting tubes (3) into the
two matching holes in the cam lever assemblies.
NOTE: Make sure the front mounting tube has the
measuring scale visible from the front of the saw.
4. Slide the table extension toward the table until it rests
against the saw table.
5. Lock both cam locking levers by pushing them in
toward the cam locking lever assemblies.
6. Drive a screw (5) into the end of the rear right hand
table extension tube (6) as a stop.
Fig. N
7
6
1
5
4
3
2
INSTALLING REAR TABLE EXTENSION (FIG. O)
1. Place the rear table extension (1) onto the two rear
table extension tubes (2).
2. Snap two location seats (3) over the two rear table
extension tubes (2).
3. Insert rear table extension tubes (2) into the two holes
in the rear of the saw table (4) and into extenson tube
brackets under the table. Position rear table support
so instruction labels are up.