Hitachi C 10RC Instruction Manual And Safety Instructions page 12

English
INSTALLING THE DUST PORT ADAPTER (FIG. I)
NOTE: A 58-37 mm dust port adapter is optional for your
convenience.
1. Attach the dust port adapter (2) to the dust port (1).
Fig. I
BLADE GUARD ASSEMBLY (FIG. J)
1. Place the blade guard on the riving knife and secure
it with the bolt (1), fl at washer (2), and nut (3).
2. Place the plunger (7) to the exhaust port of the blade
guard
INSTALLING THE RIVING KNIFE (FIG. J)
WARNING
The riving knife thickness of 2.5 mm. Make sure the
blade and riving knife are aligned on the same line.
If not, adjust the riving knife by loosening the knob
bolts. It should be less than 5 mm at all positions.
1. Rise the blade to its highest position by turning the
handwheel and tilt the blade to 45° bevel angle.
2. Loosen the screws on the table insert and remove the
table insert.
3. Place the knob bolt (4) on the riving knife bracket (5)
and the riving knife (6).
4. Tighten the knob bolt (4).
5. Replace the table insert and tighten the screw.
6.
Fig. J
7
2
2
1
6
5
4
3
1
6
INSTALLING THE CLAMP HANDLE (FIG. K)
1. Thread the clamp handle (1) through the washer (2),
pressing plate (3) into the hole (4) of the rip fence
and lock in place by tighten the nut (5) against the
fence head.
Fig. K
INSTALLING THE RIP FENCE (FIG. L)
Slide in the rip fence assembly from the end of the table
with aligning the groove in the front of the table and the
tongue on the fence bracket.
Fig. L
CHANGING BLADES (FIG. M)
To avoid injury from accidental starting, always turn
the switch off ("0") and remove the power plug from
the power source before changing the blades.
1. Loosen the screws on the table insert by a
screwdriver and remove the table insert.
2. Loosen the screw (5) and remove the plate (6).
3. Raise the saw blade to its maximum height.
4. Use the supplied open end wrench (1) to keep the
arbor from turning and the supplied box-end wrench
(2) to loosen the arbor nut. (Fig. M)
5. Remove the arbor nut (3) and outer fl ange (4).
6. Replace the saw blade. Make sure the teeth of the
blade point down at the front of the table.
7. Assemble the arbor fl ange and arbor nut back to the
saw arbor and tighten the arbor nut.
8. Replace the plate (6) and tighten the screw (5).
9. Replace the table insert and retighten the two screws.
– 12 –
4
5
1
3
2
WARNING