Assembly And Adjustments - Hitachi C 10RC Instruction Manual And Safety Instructions

English

ASSEMBLY AND ADJUSTMENTS

ESTIMATED ASSEMBLY TIME 25~40 MINUTES
STAND ASSEMBLY (FIG. A)
1. Release the stand hook (1) by sliding it to the left.
2. Unfold the wider leg set (2) on the left side of the
stand. Pull the stand locking lever (3) downward and
push down to lock in place.
3. Lift the stand up and unfold the narrower leg set (4)
on the right of the saw.
4. Pull the right side stand locking lever downward and
push to lock in place.
NOTE: Make sure the stand is locked securely.
5. Attach one roller wheel (6) to roller wheel mounting
bracket using a square neck bolt (7) and nut (8) as
shown. Repeat for other wheel.
6. Attach two L-Type clamps (9) to the front legs with
two screws (10) and nuts (11).
INSTALLING REAR SUPPORT LEG (FIG. A)
1. Install connector (A) onto bottom of stand with two
Phillips screws (long) and lock nuts.
2. Install two storage hooks (B) onto the back of the
stand using two Phillips screws (short) and lock nuts
per hook.
3. Thread rear support leg (C) into connector (A).
4. To level rear support leg to the fl oor, adjust the
leveling foot until it touches the fl oor and provides
stability to the stand and secure in position by
locking the nut against the bottom of the rear
support leg.
5. When transporting the unit, unscrew the rear support
leg and position in the hooks for storage.
Fig. A
1
7
B
4
5
C
6
8
2
10
9
11
3
A
ASSEMBLE BASE COVER TO TABLE SAW (FIG. B)
NOTE:
Your saw is supplied with the base cover
unassembled.
1. Assemble the base cover (1) to the saw base (2) by
using the 4 screws (3) in the loose parts bag supplied.
2. Tighten the 4 screws (3) before mounting the saw on
the stand.
Fig. B
3
ASSEMBLING THE TABLE SAW TO STAND (FIG. C)
1. Place stand on level surface and adjust the leveling
foot (1) on the right rear leg of stand to stabilize.
2. Place table saw on the top of stand aligning the
mounting holes in base with mounting holes in stand.
3. Place four fl at washers onto four hex. head bolts (2).
Place them through the base mounting holes and
thread into the stand mounting holes and tighten all
four bolts securely.
Fig. C
2
– 10 –
3
3
2
1
3
2
1