Starting A Firmware Update - Gigaset sl910 Manual

Updating the base firmware
Enter the IP addresses/subnet mask:
¤
Touch the ' next to the IP address/
subnet mask.
¤
Enter the IP address in the 4 fields at
the top of the display.
– If the fields are empty, the cursor is
in the left field. Once you have
entered three digits, the cursor
automatically moves to the next
field.
– If less than three digits are entered,
touch the next field to input the fol-
lowing part of the address.
– If a field is already full, touch the
field, delete the digits, enter that
part of the address. Leading zeros must not be entered in part of the address.
¤
Confirm with è.

Starting a firmware update

Prerequisite:
u
The phone is connected to the Internet (i.e., connected to a router,
u
The phone is in idle status, i.e.: no calls are being made, there is no internal con-
nection, no handset has opened a menu on the base.
Starting the firmware update manually
¤
In the Settings menu (
¤
Scroll to Firmware Update.
PIN and confirm with è.
If a new version of the base firmware is available, message New firmware available
- Update? is displayed.
¤
Press Yes to confirm.
Please note
u
The firmware update can take up to six minutes, depending on the quality of
your DSL connection.
u
During the update, the registered handsets temporarily lose their connec-
tion to the base.
76
¢
page 24), touch [
Touch the corresponding '.
¤
¤
Touch Update Firmware.
L
IP Address
192 . 168 . 2
1 2
4 5
7 8
0
Ê
System].
¤
Enter the system
. 2
è
ç
3
6
9
¢
page 74).