Design; System Designing Procedure - Mitsubishi Electric Q172DCPU User Manual

3 DESIGN

3. DESIGN

3.1 System Designing Procedure

Design the system which uses the Multiple CPU system in the following procedure.
Motion control system design
Select the Motion CPU module according to number of control axes.
Select the motion functions to be installed according to the machinery
and equipment to be controlled (selection of the programming software
packages according to the operating system software).
Select the number of Q172DLX's and design according to the each
axis control system and whether servo external signals are required
or not.
Select Q173DPX, Q172DEX and design according to whether manual
pulse generators and synchronous encoders are required or not.
Select interrupt module QI60 according to whether interrupt input are
required or not.
Select I/O modules according to the specifications of the external
equipment to be controlled.
Select the main base unit, extension base units, extension power
supply module and extension cables, and make I/O assignment
according to necessary number of Q172DLX's, Q172DEX's,
Q173DPX's, QX 's, QY 's and the number of I/O modules.
Select the servo amplifier and servo motor according to the motor
capacity and number of revolution from the machine mechanism to be
controlled each axis.
Set the servo amplifier connection by SSCNET
(dno.) and axis No..
When there is mechanical home position and home position return is
made: Proximity dog required
For speed control: Speed-position switching control signal required
When overrun prevention is necessary: Stroke limit required
When each axis stop is necessary: STOP signal required
Refer to section 2.4.4
Refer to section 2.4.5
Refer to section 2.4.6
Refer to MELSEC-Q
series manual.
Refer to section 2.4.4
Refer to section 2.4.5
Refer to section 2.4.6
Refer to the servo
amplifier manual.
Refer to section 2.4.8
and axis numbers
3 - 1
3