Overheating Protection - Miele CS 1223 Operating And Installation Instructions

Overheating protection

The induction coil is equipped with
overheating protection. Before the
induction coil gets too hot, overheating
protection cuts in in one of the following
ways:
– If the booster function is being used
it will be switched off.
– If the temperature continues to rise
after the booster function is switched
off, the power setting will be
reduced.
– If the temperature continues to rise
after the power setting has been
reduced, the induction wok will
switch off and H will appear in the
display.
^ Turn the control to "0".
The induction wok can only be used
again in the normal way after the H has
gone out.
If the control is not turned back to "0", C
and 0 will flash in the display alternately
once the induction wok has cooled
down sufficiently. To use the induction
wok again, first turn the control to "0".
The induction coil can overheat if
– the appliance is used for too long at
maximum power.
– the appliance is not well enough
ventilated.
If a drawer is fitted directly underneath
the hob, there must be sufficient space
between the drawer and its contents
and the underside of the appliance in
order to ensure sufficient ventilation for
the induction wok.
If the overheating protection device
trips again, contact the Service
department.
Safety features
21