Assembly Instructions; Tailplane Assembly - GRAUPNER EPIC Victory S Manual

Assembly instructions

The sequence of the assembly steps is designed to optimise the time needed for assembly. The
sections and steps of the assembly instructions must be followed.

Tailplane assembly

1. Start with the tailplane. First cut a 240-mm piece off one of the two 6x1x1000-mm
CRP strut belts provided. The rest of the section is needed for the wing strut. Use
a saw or wire cutters to make the cut. After cutting, clean the cut edge with a
sanding block.
2. Put fast-setting glue, Order No. 5821 in the cut-out for the strut in the elevator.
Press the strut into the cut-out until it disappears in the tailplane flush with the
outer surface.
Tip!
To do so, press the tailplane uniformly against the strut and the edge of your workbench. This ensures
that the tailplane will be straight.
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Not liable for printing errors. We reserve the right to make technical modifications.12/2011
Page 10