Quick Cycle Setup - Graco GLC 4400 Instructions Manual

4. Use the Arrow keys to move the cursor over the
TIME ON field.
F . 49
IG
NOTE: Time is displayed in HH:MM.
5. Use the UP/DOWN arrows to move up and down
through the numbers 0-9 until the first number in the
TIME ON is displayed in the field.
6. Use the RIGHT arrow to move the cursor to the next
field. Repeat step 5.
7. Repeat steps 5 and 6 until the desired time displays.
8. Press RESET. The Main Screen, page 24 displays.

QUICK CYCLE Setup

Initiate a set of lubrication events for diagnostic or test
purposes.
F . 50
IG
1. Use the UP/DOWN Arrow keys to move the cursor
over QUICK CYCLE.
2. Press ENTER to display the QUICK CYCLE setup
screen.
313855K
Quick Cycle Screen Setup
The Quick Cycle screen setup is used to setup a Trou-
bleshooting profile.
F . 51
IG
1. Use the Arrow keys to move the cursor over the
CYCLES field.
2. Press ENTER.
3. Use the UP/DOWN arrows to move up and down
through the numbers 0-9 until the first number you
want in the CYCLES field is displayed.
4. Use the RIGHT arrow to move the cursor to the next
field. Repeat step 3.
NOTE: The maximum number of Cycles you can setup
in this field is 99.
5. Use the Arrow keys to move the cursor over the
TIME ON field.
6. Press ENTER.
NOTE: Time On and Time Off in QUICK CYCLE mode
only, are displayed in Seconds.
7. Use the UP/DOWN arrows to move up and down
through the numbers 0-9 until the first number you
want to use in the TIME ON field is displayed in the
field.
8. Use the RIGHT arrow to move the cursor to the next
field. Repeat step 7.
9. Press ENTER.
10. Use the Arrow keys to move the cursor over the
TIME ON field.
11. Press ENTER.
Setup
33