Pump Off Setup; Cycle Mode Selection - Graco GLC 4400 Instructions Manual

Setup

Cycle Mode Selection

If the Cycle Mode is selected you will also be prompted
to set the desired number of cycles.
NOTE: A cycle is equal to two switch closure transitions
at the cycle switch input.
F . 28
IG
10. Use the Arrow keys to move the cursor over the
CYCLES field.
11. Press ENTER.
12. Use the UP/DOWN arrows to move up and down
through the numbers 0-9 until the first number you
want in the CYCLES field is displayed.
13. Use the RIGHT arrow to move the cursor to the next
field. Repeat step 12.
NOTE: The maximum number of Cycles you can setup
in this field is 99.
14. Press RESET. The Main Screen, page 24 displays.
NOTE: When Cycles is selected, the Cycles Icon dis-
plays is the upper right corner of the screen.
26

PUMP OFF Setup

Sets up how the PUMP OFF cycle is ended: Time,
Machine Count switch activation, or Machine Count acti-
vations limited by a maximum time.
F . 29
IG
1. Use the UP/DOWN Arrow keys to move the cursor
over PUMP OFF.
2. Press ENTER to display the PUMP OFF setup
screen.
To Set the Pump OFF Option
F . 30
IG
1. Use the Arrow keys to move the cursor over the
PUMP OFF pull-down menu.
2. Press ENTER.
3. Use the UP/DOWN Arrow keys to move cursor to
select TIME, COUNT or BOTH.
4. After you make your selection, Press ENTER.
313855K