Table of Contents
Advertisement
Discovery I
B. Decorative Panel Removal & Installation
Your appliance ships with two different side options, one is a solid
side panel (Figure 16.1) and tile side panel (Figure 16.3). There
are two of each and no left or right side, these can be changed
at anytime.
The appliances are being shipped with a solid side panel
securing clip on both sides of the appliance. Please remove
and discard pins prior to use. (Figures 16.4)
Solid Side Panel Removal
1. Remove solid panel from side by lifting up and pulling away
from appliance (use a flat tool to pry from bottom if needed).
Figure 16.5
Note: 300 degree F high temp paint can be use to repaint the
solid side panel only! DO NOT use on the rest of appliance this
requires 1200 degree F high temp paint.
Tile Panel Installation
1. Remove tile frame from side by lifting up and pulling away
from appliance. Figure 16.5 reference solid side panel re-
moval.
2. Stack non-combustible material tiles in tile frame as shown
in Figure 16.2 by sliding first tile in, bend tabs on back side,
then slide last tile in position so that it rests on tabs Figure
16.3.
3. Reattach tile frame Figure 16.6.
Tile Dimensional Requirements:
Max Thickness: 5/16"
Max Length/Width: 11-7/8" square
Min Length/Width: 11-11/16" square
Figure 16.1
Figure 16.2
WARNING!
Use only noncombustible materials as a decorative tile.
16
Figure 16.4
Figure 16.3
7039-174C
Securing
Clip
Figure 16.5
Figure 16.6
August 01, 2016
Advertisement
Table of Contents
