Baffle & Brick Set Removal; Baffle & Brick Set Installation - Quadra-Fire CASTILE-B series Owner's Manual

CASTILE FREESTANDING
D. Baffle & Brick Set Removal
1. Follow proper shutdown procedures.
2. The top baffle has a hook on the bottom left side that
rests on the top lip of the cast brick. There is a tab on
the bottom right side that hooks into the side bracket.
Remove the top baffle by first pulling the baffle forward
until back edge drops down. Then slide baffle back until
the front edge clears the shelf that it had been resting
on (Figure 28.2).
3. The top baffle must be removed before you can remove
the right and left brick. Remove the right brick by holding
top lip of brick and lifting up, then push outside edge
back. Slide brick to the right until it is flush with the
firebox. Rotate the inside edge of the brick forward and
remove brick. Repeat for left brick (Figure 28.3).
Figure 28.2
Remove Right
& Left Brick
Figure 28.3
Vacuum
Exhaust Area
Figure 28.4
E. Baffle & Brick Set Installation
1. Place right brick in behind the right bracket and then
slide to the left so the tabs are behind the center brick
(Figure 29.1).
2. The brick will be flush against the back wall and the
bracket's notches will be exposed (Figure 29.2).
3. Pull the right edge of the brick forward and slide the
brick into the notches both top and bottom of right
bracket (Figure 29.3).
28
4. Repeat for left brick.
5. Insert baffle into top front of firebox and then raise up
6. The baffle does not completely cover the top of the
Figure 29.1
Right Brick
Removed
Figure 29.2
7021-155H
the bottom end and insert baffle tab into notch on the
right bracket to lock into place (Figure 29.5). Place the
left side hook of the bottom baffle over the top of brick
for stability.
firebox. There is an opening as shown in Figure 29.6.
Do not remove rope
from center brick
Brick is flush against back wall
Brick in
front of
clip and
Notches
exposed
Tabs
February 11, 2019