Uconnect Voice Command - Jeep 2016 WRANGLER User Manual

UCONNECT VOICE COMMAND

Voice Command Operation
The Uconnect Voice Command system allows you to control your AM, FM radio,
satellite radio, disc player, HDD, Uconnect Phone, a memo recorder, and supported
portable media devices.
• When you push the "Voice Command" button
or steering wheel, you will hear a beep. The beep is your signal to give a command.
If you do not say a command within a few seconds, the system will present you with
a list of options. If you ever want to interrupt the system while it lists options, push
the "Voice Command" button
NOTE:
U.S. residents visit driveuconnect.com for more info on which voice command
features apply to your vehicle. Canadian residents visit driveuconnect.ca for more
info on which voice command features apply to your vehicle.
• Start a dialogue by pushing the "Voice Command" button
beep. The beep is your signal to give a command. Below are a list of voice
commands for each of the different modes:
While In:
Main Menu
Radio Mode
ELECTRONICS
, listen for the BEEP, and say your command.
Voice Command Example:
"Radio AM" (to switch to the AM radio mode)
"Radio FM" (to switch to the FM radio mode)
"Satellite Radio" (to switch to the Satellite radio mode)
"Disc" (to switch to the disc mode)
"USB" (to switch to the USB mode)
"Bluetooth Streaming" (to switch to the Bluetooth
Streaming mode)
"Memo" (to switch to the memo recorder)
"System Setup" (to switch to system setup)
"Frequency" (to change the frequency)
"Next Station" (to select the next station)
"Previous Station" (to select the previous station)
"Radio Menu" (to switch to the radio menu)
"Main Menu" (to switch to the main menu)
located on the radio faceplate
, you will hear a
85