Making A Phone Call; Receiving A Call - Accept (And End); Mute (Or Unmute) Microphone During Call; Transfer Ongoing Call Between Handset And Vehicle - Jeep WRANGLER User Manual

Making A Phone Call

• Push the "Phone" button
• After the BEEP, say "dial" (or "call" a
name).
• After the BEEP, say number (or name).
Receiving A Call — Accept (And End)
• When an incoming call rings/is announced
on Uconnect, push the "Phone" button
.
• To end a call, push the "Phone" button
.
Mute (Or Unmute) Microphone During
Call
• During a call, push the "Voice Command"
button .
• After the BEEP, say "mute" (or "mute off").
Transfer Ongoing Call Between Handset
And Vehicle
• During a call, push the "Voice Command"
button .
• After the BEEP, say "transfer call."
236

Changing The Volume

. • Start a dialogue by pushing the "Phone"
button , then adjust the volume during
a normal call.
• Use the radio ON/OFF VOLUME rotary knob
to adjust the volume to a comfortable level
while the Uconnect system is speaking.
Please note the volume setting for
Uconnect is different than the audio
system.
WARNING!
• Any voice commanded system should be
used only in safe driving conditions fol-
lowing applicable laws regarding phone
use. Your attention should be focused on
safely operating the vehicle. Failure to
do so may result in a collision causing
you and others to be severely injured or
killed.
• In an emergency, to use Uconnect
Phone, your mobile phone must be:
• turned on
• paired to Uconnect Phone
• have network coverage
UCONNECT VOICE
COMMAND

Voice Command Operation

The Uconnect Voice Command system allows
you to control your AM, FM radio, disc player,
HDD, Uconnect Phone, a memo recorder,
and supported portable media devices.
• When you push the "Voice Command"
button located on the radio faceplate
or steering wheel, you will hear a beep. The
beep is your signal to give a command. If
you do not say a command within a few
seconds, the system presents you with a list
of options. If you ever want to interrupt the
system while it lists options, push the
"Voice Command" button
the BEEP, and say your command.
, listen for