Table of Contents
Advertisement
SMA Solar Technology AG
Procedure:
1. If another PV system with BLUETOOTH is located within 500 m of your system, determine a
free NetID at the planned mounting location of every BLUETOOTH device and make a note of
this (see Sunny Explorer documentation).
2. For all devices that are to communicate with the Sunny Home Manager via BLUETOOTH, set
the previously noted free NetID and commission the devices (see BLUETOOTH device- or
BLUETOOTH Piggy-Back documentation).
3. Note the serial numbers of the Sunny Home Manager and all other SMA devices. For each
SMA radio-controlled socket, also note the load to be assigned to the particular socket.
4. Read off the following data from the SMA devices:
• Sunny Home Manager: serial number and registration ID (see type label on the back of
the Sunny Home Manager).
• All SMA radio-controlled sockets: serial number and connected load
• All other SMA devices: serial number
5. With the exception of the Sunny Home Manager and the SMA radio-controlled socket,
commission all BLUETOOTH devices of the PV system (see BLUETOOTH device
documentation).
5.2.2
Setting the NetID on the Sunny Home Manager
Requirement:
☐ The BLUETOOTH PV system must be commissioned (see Section 5.2.1, page 34).
Procedure:
• Use a screwdriver to turn the arrow of the rotary switch NetID to the desired NetID (blade
width of the screwdriver: 2.5 mm).
5.2.3
Setting the NetID on the SMA Radio-Controlled Socket
Setting the NetID for the First Time
1. Insert the SMA radio-controlled socket into an outlet.
☑ The upper horizontal LED glows red for approximately ten seconds, then the vertical
LEDs glow green for approximately four seconds.
2. As soon as the LED display shows 0, keep tapping the touch key until the LED display shows
the desired NetID.
3. To adopt the NetID, wait five seconds. During this time, do not tap the touch key.
Changing the NetID
Requirements:
☐ The SMA radio-controlled socket must be inserted in an outlet.
☐ The upper horizontal LED must be glowing orange or green.
Installation Manual
5 Mounting and Commissioning Preparations
HoMan-IA-en-20
35
Advertisement
Table of Contents
