Table of Contents
Advertisement
user-MAintenAnce
instructions
Procedures not specifically
explained in this manual must
be performed only by a qualified
technician.
froM AccidentAl
operAtion: turn off tool,
detach air supply, safely
discharge any residual air
pressure in tool, and release the
throttle before performing any
inspection, maintenance, or
cleaning procedures.
to preVent serious injurY
froM tool fAilure: do not
use damaged equipment. if
abnormal noise, vibration, or
leaking air occurs, have problem
corrected before further use.
to preVent explosion:
lubricate the tool only with
specified lubricants. Lubricate
the air inlet using only pneumatic
tool oil. lubricate the internal
mechanism using only white
lithium grease. other lubricants
may damage the mechanism
and may be highly flammable,
causing an explosion.
cleaning, Maintenance, and
lubrication
note: These procedures are in addition to
the regular checks and maintenance
explained as part of the regular operation
of the air-operated tool.
1.
daily - Air supply Maintenance:
Every day, perform maintenance on
SKU 67996
to preVent
serious injurY
for technical questions, please call 1-800-444-3353.
the air supply according to component
manufacturers' instructions. The
lubricator's oil level needs to be
maintained and the moisture filter must
be regularly drained. Performing routine
maintenance on the air supply will allow
the tool to operate more safely and will
also reduce wear on the tool.
2.
Quarterly (every 3 months) - tool
disassembly, cleaning, and
inspection: Have internal mechanism
cleaned, inspected, and lubricated by
qualified technician. If vanes need
replacement, all vanes should be
replaced as a set.
3.
After each use, wipe down Cut-Off Tool
with clean cloth, remove all dirt, oil and
grease from Cut-Off Tool. If necessary,
use a mild detergent. Do not use
solvents, as damage to Tool may occur.
Do not immerse Tool in any liquids.
Page 12
Advertisement
Table of Contents
