Advertisement
Brought to You by www.snapwhole.com
Cylinder (14d)
Regulator (4d)
WARNING: Examine your chisels/bits before using them. If a chisel is dull or
cracked do not use it. Replace worn or broken chisels with approved
replacement chisels/bits from Harbor Freight Tools.
2.
Connect the air hose to the Air Inlet (9d) and turn on the compressor (not
included).
3.
Grip the Air Hammer with both hands firmly and put the chisel/bit tip up
against the workpiece you wish to chip.
4.
Gently squeeze the Trigger (16d) and move slowly along the workpiece. Do
not push down on the Air Hammer; let it do the work. If it does not do the
intended job to satisfaction, examine your bit to see if it is worn or dull.
Warning!! Always disconnect from the air source before examining or changing bits.
5.
When you are finished, turn off the air supply and then hold the Air Hammer in
a safe direction and Squeeze the trigger to bleed off the remaining air. Then,
disconnect the air hose.
Warning!! Always disconnect from the air source before attempting
maintenance.
1.
After each use, wipe the Air Hammer down with a lint free cloth.
2.
Make sure there are no concrete chips, dirt, or debris in the Retainer Spring (15d).
3.
Before storage, add a small quantity of high quality pneumatic oil in the Air
Inlet (9d) and operate the tool for a couple of seconds to lubricate and protect
the internal mechanism.
SKU 46446
For technical questions and replacement parts, please call 1-800-444-3353
Retainer Spring (15d)
Trigger (16d)
Air Inlet (9d)
Maintenance
Chisel
Page 21
Advertisement
