Table of Contents
Advertisement
Coupler of an hose (not included) onto
the Quick Connector.
WArning! to preVent serious
injurY froM AccidentAl
operAtion: do not install a female
quick coupler on the tool. Such a
coupler contains an air valve that will
allow the air tool to retain pressure and
operate accidentally after the air supply
is disconnected.
note: Air flow, and therefore tool
performance, can be hindered by
undersized air supply components.
3.
The air hose must be long enough to
reach work area with enough extra
length to allow free movement while
working.
4.
Make sure tool's throttle or switch is
in the off position; refer to Operation
section for description of controls.
5.
Close the in-line safety valve between
the compressor and the tool.
6.
Turn on air compressor according to
manufacturer's directions and allow it to
build up pressure until it cycles off.
7.
Adjust air compressor's output regulator
so that air output is enough to properly
power the tool, but the output will not
exceed the tool's maximum air pressure
at any time. Adjust the pressure
gradually, while checking the air output
gauge to set the right pressure range.
8.
Inspect air connections for leaks. Repair
any leaks found.
9.
If tool will not be used at this time,
turn off and detach air supply, safely
discharge any residual air pressure, and
release throttle to prevent accidental
operation.
SKU 67996
for technical questions, please call 1-800-444-3353.
note: Residual air pressure should not be
present after the tool is disconnected
from the air supply. However, it is a
good safety measure to attempt to
discharge the tool in a safe fashion after
disconnecting to ensure that the tool is
disconnected and unpowered.
operAting instructions
read the entire iMportAnt
sAfetY inforMAtion
section at the beginning of this
manual including all text under
subheadings therein before set up
or use of this product.
froM AccidentAl
operAtion: turn the power
switch of the tool off and unplug
the tool from its electrical outlet
before installing accessories.
installing the 3" cutting Wheel
1.
The Cutting Wheel MUST be:
•
rated to at least 18,000 RPM.
•
no larger than 3" in diameter with a 3/8"
arbor hole.
•
dry and clean.
•
proven undamaged by inspection.
do not operate this tool without
the Wheel guard properly
installed.
to preVent
serious injurY
to preVent
serious injurY:
Page 9
Advertisement
Table of Contents
