Inspection, Maintenance, And Cleaning - Central Pneumatic 36567 Assembly And Operating Instructions Manual

Brought to you by Augusta Flint
1. WARNING! Always make sure the Trigger (24) is in its "OFF" position,
and disconnect the Shear from its compressed air supply before performing
any inspection, adjustments, maintenance, or cleaning.
2. Before each use, inspect the general condition of the Shear. Check for loose
screws, misalignment or binding of moving parts, cracked or broken parts,
damaged air hoses, loose, cracked, or bent Blades (32, 34, 35), and any other
condition that may affect its safe operation. If abnormal noise or vibration occurs,
have the problem corrected before further use.
Do not use damaged equipment.
3. Daily: With a soft brush, cloth, or vacuum, remove all dust and debris from the
Shear. Then, use a premium quality, lightweight machine oil to lubricate all mov-
ing parts.
4. To replace the Blades: Use only the recommended replacement Blades (32, 34,
35) for this Shear (SKU 36583 available from Harbor Freight Tools). Remove the
two Lock Screws (30) and two Lock Nuts (31) from the Cutter Housing (38) of the
Shear. Remove the Center Blade (34) first. Then remove the Left Blade (32),
Right Blade (35), and the two Bushings (33). Install the new Blades. Place the
two Bushings between the new Left and Right Blades, and insert into the Cutter
Housing. Thread in the two Lock Screws, and tighten the two Lock Nuts.
(See Figure C.)
SKU 36567
36567 manual.pmd

INSPECTION, MAINTENANCE, AND CLEANING

For technical questions, please call 1-800-444-3353.
8
REV 07k
Page 8
11/19/2007, 7:44 AM