Removing Power From The System; Control Panel; Chassis Cover - Supermicro SUPERSERVER 1028UX-LL1-B8 User Manual

SUPERSERVER 1028UX-LL1-B8/LL2-B8/LL3-B8 User's Manual
Hot-Swap Drive Bays (10)
Power Supplies Rear I/O Ports
(see Figure 5-2)
Figure 6-1. Chassis Front and Rear Views
6-2

Removing Power from the System

Before performing most setup or maintenance tasks, use the following procedure
to ensure that power has been removed from the system.
1. Use the operating system to power down the system <or node>, following the
on-screen prompts.
2. After the system has completely shut-down, carefully grasp the head of the
power cord and gently pull it out of the back of the power supply. If your system
has dual power supplies, remove the cords from both power supplies.
3. Disconnect the cord from the power strip or wall outlet.
6-3

Control Panel

The control panel (located on the front of the chassis) must be connected to the
JF1 connector on the serverboard to provide you with system status indications. A
ribbon cable has bundled these wires together to simplify the connection. Connect
the cable from JF1 on the serverboard to the appropriate header on the Control
Panel PCB (printed circuit board). Make sure the red wire plugs into pin 1 on both
connectors. Pull all excess cabling out of the airflow path.
The control panel LEDs inform you of system status. See "Chapter 3: System
Interface" for details on the LEDs and the control panel buttons. Details on JF1 can
be found in "Chapter 5: Advanced Serverboard Installation."
Control Panel
USB
Ports
PCI Slots
6-2
6-4

Chassis Cover

Release Buttons
6-2. Removing the Chassis Cover
Before operating the system for the first time, remove the protective film over the
cover of the chassis, in order to allow for proper ventilation and cooling.
Removing the Chassis Cover and Protective Film
1. Peel off the protective film covering the top cover and the top of the chassis
2. Press the two release buttons and slide the cover toward the rear.
3. Lift the top cover up.
Check that all ventilation openings on the top cover and the top of the chassis are
clear and unobstructed..
Chapter 6: Advanced Chassis Setup
6-3