Information Mode - Power Measurement ION 6200 Installation Manual

Information Mode

Manufacturer ID Number
Firmware Version
Original Equipment Manufacturer (OEM)
Meter Options (e.g. enhanced measurements,
digital outputs, communications)
Mode
Information Mode
ENTER Information mode by pressing
the Enter, Up and Down buttons
together and holding for 2 seconds.
EXIT Information mode with the same
button sequence.
Meter Settings
Configurable meter settings are listed in "Configurable Settings" on page 19.
Configuration Software
To monitor, configure, or perform energy resets on your meter, Power
Measurement offers a number of software alternatives. For information on
the availability of configuration and system software, refer to our web site at
www.pwrm.com, or contact Technical Support.
In Information mode, you can verify that the front panel LEDs operate, and
view meter information (e.g. firmware version).
Verifying that the LEDs and Display Function
When you enter Information mode, every LED on the front panel lights, and
each line of the display flashes with four number eights ("8888") and four
decimal points ("....") per line. This continues for 3 seconds, and indicates
that the front panel LEDs and display are operating.
Information Mode Screens
Screen
1
1
The options code specifies the type of Options Card that is in your meter.
To view a list of Options Cards with corresponding options codes, refer to
the table "Options Card Combinations" on page 6.
Button Functions in Information Mode
Viewing Meter Information
After the LED and display operation verification is completed, the meter
automatically displays the first of four screens that provide meter information.
Press the Up or Down buttons to scroll through these screens.
No string; area is used for the meter
manufacturer/serial number.
r
Button
Move to the previous Information
mode screen.
Move to the next Information
mode screen.
String
Function
25