4.1
4.1
User
User
configuration
configuration
4.1 User
4.1
User configuration
configuration process
After USR-WIFI232-A/B/C module electric starter, based on user pre-set parameters,
automatically connect to wireless networks and servers, and enter the working mode is set to
open in accordance with the default serial port parameters.
The parameters which need to configure include:
�
Wireless Network Parameters
�
Wireless Network Name(SSID)
�
Security Mode
�
Encryption Key
�
TCP/UDP Linking Parameters
�
Protocol Type
�
Link Type(Server or Client)
�
Target Port ID Number
�
Target Port IP Address
�
Serial Port Parameters
�
Baud Rate
�
Data Bit
�
Parity (Check) Bit
�
Stop Bit
�
Hardware Flow Control
�
Work Mode Selection
�
Transparent mode/Serial command mode/GPIO mode
The following sections will introduce specific to each part in detail.
4.2
4.2
Working
Working
mode
mode
4.2
4.2 Working
Working mode
mode
4.2.1 Transparent Mode
USR-WIFI232-A/B/C modules support serial interface transparent transmission mode. The benefit
of this mode is achieves a plug and play serial data port, and reduces user complexity furthest. In
this mode, user should only configure the necessary parameters. After power on, module can
automatically connect to the default wireless network and server.
As in this mode, the module's serial port always work in the transparent transmission mode, so
users only need to think of it as a virtual serial cable, and send and receive data as using a
simple serial. In other words, the serial cable of users' original serial devices is directly replaced
with the module; user devices can be easy for wireless data transmission without any changes.
Jinan USR IOT Technology Limited
USR-WIFI232-A/B/C User Manual
process
process
process
Page 26 of 93
http://www.usriot.com
tec@usr.cn