Uart Interface; Power Interface; Modules Function Description - Jinan USR IOT Technology WIFI232-A User Manual

3.5.3 UART Interface

UART interface is the serial data transmition interface mainly used for USR-WIFI232-A/B/C
modules.
User can add RS-232 chipset on user board and convert the signal to RS-232 voltage to
communicate with outside equipment or sensors. USR-WIFI232-A/B/C modules UART interface
include 4 general signals: TXD/RXD/RTS/CTS. The hardware reference design with RS-232
chipset as following:
Figure 21
Notes: Notes:
Notes: TXD pin is also hardware configuration pin internal module. So this pin MUST pull-down Notes:
during module power up. USR-WIFI232-A/B/C modules provide internal pull-down resister, user
can't add pull-up/pull-down resister on user board, which may cause module can't work.

3.5.4 Power Interface

USR-WIFI232-A/B/C module support single +3.3V power supply. The peak current shall about
350mA and normal WiFi working current shall about 200mA. The power save (WiFi OFF) mode
will about 100mA
Decoupling at power pin suggested, At least one 100uF and one 10uF capacitor required at user
board and put near module power input pin will increase the reliability and performance.
4 4 4 4 Modules Modules Modules Modules F F F F unction unction unction D D D D escription unction
Jinan USR IOT Technology Limited
USR-WIFI232-A/B/C User Manual
Figure Figure 10 10 UART UART Interface Interface
Figure Figure 10 10 UART UART Interface Interface Reference
escription escription
escription
Page 25 of 93
http://www.usriot.com
Reference Reference Design Design
Reference Design Design
tec@usr.cn