Planet Networking & Communication IP-1000PT User Manual page 18

1.2 WAN Port IP Address
1) Pick up phone and press '****' to start IVR;
2) Choose '1' and then '2', and the VIP-1000PT/VIP-1000T will report on
the current WAN Port IP Address;
3) Input the new WAN port IP address and end it with '#'.
◆ Use '*' to replace '.'. User can input 192*168*20*168 to set the
new IP address 192.168.20.168.
◆
Press the '#' key to indicate that you have finished.
4) 'Operation successful' will be reported if it's done properly.
1. If you want to quit, press '**'.
2. Set the WAN IP, and then Subnet Mask, Gateway and DNS (Operation
Code 1.2, 1.3, 1.4 and 1.5); otherwise, the new setting will be invalid.
1.3 WAN Port Subnet Mask
2) Pick up phone and press '****' to start IVR;
3) Choose '1' and then '3', and the VIP-1000PT/VIP-1000T will report on
WAN port subnet mask;
4) Input a new WAN port subnet mask with '#' at the end.
◆ Use '*' to replace '.'. User can input 255*255*255*0 to set the
new WAN port subnet mask 255.255.255.0.
◆ Press the '#' key to indicate that you have finished.
5) 'Operation successful' will be reported if it's done properly.
If you want to quit, press '**'.
1.4 Gateway
1) Pick up phone and press '****' to start IVR;
2) Choose '1' and then '4', and the VIP-1000PT/VIP-1000T will report on
the current gateway;
3) Input the new gateway and end it with '#'.
◆ Using '*' to replace '.', user can input 192*168*20*1 to set the
new gateway 192.168.20.1.
◆ Press the '#' key to indicate that you have finished.
4) 'Operation successful' will be reported if it's done properly.
If you want to quit, press '**'.
1.5 DNS
High Definition PoE/Non-PoE IP Phone
- 18 -
VIP-1000PT/VIP-1000T