Power Up And Power Down - Vivotek NR8401 User Manual

VIVOTEK - Built with Reliability

Power Up and Power Down

To power up and power down,
On the initial configuration:
1. Make sure the power switch on the rear panel is in the OFF (O) position, connect the power
cord between the system and power outlet.
2. Turn on the system by by turning the power switch to the ON (I) position.
After the initial connection,
1. Press the power button for 1 second to power on.
2. Press the power button for 1 second to power down. the system should start flushing the
cache contents in system memory and gracefully shut down.
3. If the power-down sequence does not proceed normally, press the power button for 4
seconds to shut down.
WARNING:
1. No storage system is completely fail-safe. Damage to data might occur due to file system
corruption, operating system malfunction, virus infection, HDD component failures, and so on.
Therefore, it is highly recommended to regularly back up your data, and VIVOTEK disclaims
responsibilities of data loss or recovery.
2. Always power off the system using the power button. Do not disconnect the power cord while
the system is still operating. Doing so will result in data inconsistencies. The normal power-off
procedure allows cached data to be written to disks.
NOTE:
If system buzzer is sounded, turn it off in Settings > Logs > Error page. Click the Stop
buzzer sound button.
Serious system faults, such as a missing volume, can trigger the system buzzer. Verify the
cause of system fault and turn off the buzzer.
24 - User's Manual