7.1.2
Setup Procedure
Follow the procedure below to setup the printer for the Windows Networking environment.
Procedure
Setup the port status and transport protocol at the printer.
• When using NetBEUI
From the touch panel display, select Enable for the port status of SMB
(factory setting: Enable), followed by On for NetBEUI (factory setting: On).
• When using TCP/IP
From the touch panel display, select Enable for the port status of SMB (factory
setting: Enable), followed by On for TCP/IP (factory setting: On).
Change the printer and workgroup name.
If necessary, change the SMB setting file, "config.txt" as well as the printer and
workgroup name from the host computer.
Install the printer driver to the host computer.
"7.2 Setting NetBEUI in Printer"
"7.3 Setting TCP/IP in Printer"
"7.4 Changing Printer and Workgroup Name"
"7.5 Auto Driver Downloading"
7.1 Introduction
7
103