Table of Contents
Advertisement
15.5
This section provides information on the possible causes, verifying methods and recommended actions
pertaining to errors which may occur when the printer is used with TCP/IP (LPD).
15.5.1 When Using Windows 95/98/Me
Cause
The printer and the PC are
connected to different
networks.
An error has occurred on the
network between the PC and
the printer. Connection cannot
be established.
The IP address of the printer is
entered wrong.
The printer is switched off
after the print instruction has
been sent from the PC. Or the
print instruction is sent to the
printer which is switched off.
Print instructions from
multiple PCs are sent to the
printer at the same time.
Printing files cannot be
spooled due to insufficient
disk capacity of the PC.
Using TCP/IP
Status Display
Unable to print (Network Error)
Verification
Check with the system administrator of the network
to verify that the network connecting the PC and that
connecting the printer are linked by a router or a
gateway.
Action
Connect the printer directly to the network
connecting the PC.
Status Display
Unable to print (Network Error)
Verification
-
Action
Ask the system administrator of the network to check
the network for errors.
Status Display
Unable to print (Network Error)
Verification
From the printer window, select Properties from the
"Printer" menu. Click the "Details" tab of the dialog
box displayed. Then select Port Settings. Compare
the IP addresses in the "FX TCP/IP DPU Port Setup"
dialog box and the printer settings list.
Action
Enter the correct IP address set at the printer, in the
"FX TCP/IP DPU Port Setup" dialog box.
Status Display
Unable to print (Network Error)
Verification
Check whether or not the printer is switched on.
Action
Switch on the printer.
Status Display
Unable to print (Network Error)
Verification
-
Action
- (
Printing will be reprocessed automatically.
Status Display
Unable to print (Spool Error)
Verification
Double-click My Computer and right-click the disk
installed with Windows 95/98/Me (e.g. C-drive).
Select Properties from the menu displayed and the
check the free space available.
Action
After erasing unnecessary files to increase the free
space available, select Pause Printing from the
"Document" menu of the "Printer" window to enable
printing to restart.
"12.1.2 Printer Settings List" for the way to output
a printer settings list.
15
)
223
Advertisement
Table of Contents
