Table of Contents
Advertisement
7.2 Setting NetBEUI in Printer
7.2.2
7
106
Select On for NetBEUI.
Select Save twice.
Select Close twice and then Exit Tools.
The machine will be rebooted.
Other Settings
If necessary, define the settings for the following items at the printer. However, there is no
need to change the factory setting of these items for normal usage.
• SMB Print Mode
• SMB PJL Switch
• SMB Spool
Refer to "Chapter 13 Configuring by the Tools Mode Screen".
• * If the optional PostScript software kit is installed, factory setting will be Auto.
• With SMB, you can store the print data output from the application in the spool file of
the printer temporarily to be processed for printing. Set the spool mode by using the
SMB spool of the receive buffer capacity.
Spool mode:
The mode which stores print data output from the application in the spool file of the
printer temporarily to be processed for printing. You can choose to save the spool file
in either the RAM disk which has used the printer memory or the hard disk connected
to the printer. As the processing of print data after spooling will be done in the
printer, the application in the client is released sooner. Requests from multiple clients
can be processed at the same time.
Non spool mode:
The mode which processes printing while the print data output from the application is
being received by the printer. When the printer is processing printing request from a
client, printing request from other clients cannot be received.
(Factory setting: PCL*)
(Factory setting: On)
(Factory setting: Hard Disk spool)
Advertisement
Table of Contents
