Table of Contents
Advertisement
1.7
After setting or checking the IP address, activate the port to be used and the UDP agent. This section
1
describes the procedure to set the LPD port to Enable (factory setting: Enable) as well as the UDP agent to
On (factory setting: On) as we will be using remotely controlled software like Auto Configuration.
• Refer to "Chapter 7 Setup for Windows Networking" when using SMB port and to "Chapter 8 Setup
• Refer to the manuals that come with the PostScript software kit when using EtherTalk port.
1.7.1
18
Setting Port
for NetWare" when using NetWare port.
Activating Port
Activate the LPD port by using the touch panel display based on the following
procedure:
Procedure
Press the Settings/Meter Check button on the control panel and on the screen
displayed, touch Tools Mode.
Enter the access number of the system administrator and touch Confirm.
The factory default of the access number is "11111".
Advertisement
Table of Contents
