Setup For The Printer; Setting The Port To Enable - Panasonic DA-PC700 Operating Instructions Manual

8.3
This section describes the procedure to set the port for NetWare interface to Enable (factory setting:
Disable), activate the protocol to be used, print the printer settings list and check the device name.
8.3.1

Setting the Port to Enable

Activate the NetWare
Procedure
Press the Settings/Meter Check button on the control panel and select Tools
Mode on the screen displayed.
Enter the access number of the system administrator and touch Confirm.
The factory setting of the access number is "11111".

Setup for the Printer

®
port by the following procedure:
When setting the port to Enable leads to insufficient memory, a message about the
insufficient memory may be displayed on the control panel and the port status may be
set to Disable automatically. If this happens, set the ports which are not in use to
Disable and change the memory size.
8
125