Safety Information - Iso-Tech ICM 136R Instruction Manual

Safety Information

For safe operation of this clamp-multimeter,
read these instructions completely before
you use it and comply with them fully.
Failure to observe these warnings can
result in severe injury or death.
- If possible, do not work alone, so
assistance can be given if required.
- Do not use the clamp-multimeter or
test-leads if they are damaged.
- Do not use the clamp-multimeter if it is not
operating correctly, or if it is wet.
- Use the clamp-multimeter only as
specified in these Operating Instructions,
or the protection provided by it may be
impaired.
- Use extreme caution and wear Personal
Protective Equipment when taking
measurements where Hazardous Live
parts could be Accessible.
- Use caution when measuring or working
near voltages above 30 V ac rms, or
60 V dc. These voltages may cause a
shock.
- Do not allow fingers to protrude beyond
the Tactile Barrier when fitting or
removing the instrument from around a
Hazardous Live conductor, as this may
cause a shock.
Symbols as marked on the Clamp-
multimeter and instructions
Risk of electric shock
Refer to operating instructions.
DC measurement
Equipment protected by double or
7
reinforced insulation

Battery
Earth
AC measurement
Conforms to EU directives
May be used on uninsulated

Conductors.
2