Cab-1 Remote Controller Commands For Your Locomotive; Addressing Your Non-Powered A-Unit In The Trainmaster Command Control Environment - Lionel F3 Owner's Manual

TrainMaster Command Control operations
Addressing your non-powered A-unit in the TrainMaster Command
Control environment
Example
Address Locomotive #1
Set PowerMaster to CMD or traditional
power supplies to full throttle (no more
than 19 volts)
Press ENG
Press 1 (the ID#)
Throttle up/press any command button

CAB-1 Remote Controller commands for your locomotive

Rear coupler releases.
Activates the
numeric keypad.
Press AUX2 to turn
your locomotive's
headlight on and off.
Y our Command-equipped
non-powered A-unit comes
factory-programmed with an ID# of
"1." To get your locomotive in action,
set PowerMasters to CMD or set all
power supplies on full (no more than
19 volts). Press ENG and 1 on your
CAB-1 Remote Controller.
the rear of the train, the headlight
is on when the train is in reverse.
6
Press DIRECTION to
turn on the headlights.
Because this unit faces
Beneath this panel
SET L M H