Table of Contents
Advertisement
TrainMaster Command Control operations
CAB-1 Remote Controller commands
T
he CAB-1 Remote Controller commands are detailed below. The corresponding RailSounds
sound system effects are in bold italic type.
Releases the ElectroCoupler on the front of the
locomotive. Coupler release sound.
Releases the ElectroCoupler on the rear of the
tender. Coupler release sound.
Activates the numeric keypad.
Short air release sound.
Controls switch direction. Toggles all directional
lights on/off.
Accelerates the locomotive with a clockwise
rotation. Decelerates the locomotive with a
counter-clockwise rotation. Speed-dependent
RPM sounds.
Activates the locomotive's horn. Release the button
to discontinue the sound. Horn sound.
Toggles the bell sound on and off.
Bell sound.
Changes the locomotive's direction. The locomotive
decelerates to a stop and continues in the opposite
direction when you increase the throttle. Air
release sound.
Increases the locomotive's speed while the button is
pressed. Release the button to return to the initial
speed. Labored prime mover.
Decreases the locomotive's speed while the button is
pressed. Squealing brake sounds.
Shuts down all PowerMasters on your railroad. Stops
all TrainMaster Command Control-equipped
locomotives in operation. Use HALT only in
emergency situations.
SET
L
32 speed steps with low
momentum
M 100 speed steps with low
momentum
H
100 speed steps with medium
momentum
19
L
M
H
Advertisement
Table of Contents
