Omni 3600 Base Communications Ports; Telephone Line Ports - VeriFone Omni 3600 Installation Manual

O 3600 B
MNI ASE

Omni 3600 Base Communications Ports

CAUTION
WARNING
Omni 3600 Base
Communications
Ports
NOTE
WARNING
Telephone Line
Ports
28
O 3600 I
MNI NSTALLATION
Conserve battery power by turning the Omni 3600 terminal off when not in use. If
the terminal is not to be used for several days, remove the battery from the
terminal as it continues to discharge even when the terminal is turned off.
If the Omni 3600 base unit is not plugged in, remove the smart battery from the
dock to avoid the smart battery discharging in the Omni 3600 base unit.
On initial use, allow the Omni 3600 smart battery to charge a maximum of 4 hours
and fully discharge during normal operation to ensure reliable battery operation.
See Smart Battery for charge/discharge procedures.
Do not dispose of batteries in a fire. Li-ion batteries must be recycled
or disposed of properly. Do not dispose of Li-ion batteries in municipal
waste sites.
The communications ports are located on the back of the Omni 3600 base (see
Figure 25). When the Omni 3600 terminal is docked in the Omni 3600 base, a
communication port in the terminal is opened, and data can transfer from the
Omni 3600 terminal back and forth through the Omni 3600 base over the modem
connection to and from your service provider or merchant contact.
The Omni 3600 base must be plugged into power to establish communications
connections.
Figure 25 Omni 3600 Base Connection Ports
Do not remove the Omni 3600 terminal from the Omni 3600 base during data
transfers. This terminates the connection and data loss may result.
There are two RJ11-type modular phone jacks
Omni 3600 base to a telephone line:
•
The first port is identified by a telephone-shaped Telset icon shown at left. Use
this port to connect a telephone to the terminal (pass-through connection)
•
The second port is identified by the Telco icon shown at left. Use this port to
directly connect the Omni 3600 series terminal to a telephone wall jack
G
UIDE
TELSET TELCO RS-232 POWER PORT
PORT PORT PORT
(Figure 25) to connect the