Smart Battery Removal; Smart Battery Charging - VeriFone Omni 3600 Installation Manual

Figure 4
Smart Battery To remove the smart battery, press the locking tab at the top of the battery and pull
Removal
the smart battery from its slot.
Smart Battery On initial use, the smart battery must be fully charged and fully discharged
Charging
through normal operation. After unpacking your Omni 3600 terminal, install the
battery and connect the power pack to the unit for 4 hours. Disconnect the power
pack and allow your Omni 3600 terminal to remain on until the smart battery
completely discharges. Reconnect the power pack to the unit and allow the smart
battery to recharge a maximum of 4 hours.
It is also recommended that the smart battery receive a periodic full discharge. To
ensure a full discharge, use the unit until the battery is fully drained.
To determine the charge state of the battery, push the "test button" icon (shown in
Figure
battery each indicate 25% of the charge state. When the battery charge state
reaches 10%, the
battery charge state displays at the bottom of the first copyright screen when the
terminal is turned on.
NOTE Conserve battery power by turning the Omni 3600 terminal off when not in use. If
the terminal is not to be used for several days, remove the battery from the
terminal as it continues to discharge even when the terminal is turned off.
The smart battery has a safety circuit to protect the Li-ion cells from overcharging
and over-discharging. If the battery is over-discharged, the safety circuit shuts
down the battery and none of the indicator LEDs (see
pack blink. The battery must then be recharged to restore operation.
The Omni 3600 terminal automatically shuts off when the smart battery reaches
NOTE
the critically low charge state. If this occurs, the smart battery must recharge a
minimum of 1/2 hour before it can power the terminal. It make take several
recharge attempts to reset the safety circuit when charging a smart battery that
has reached a critically low charge state.
Install the Smart Battery
5) on the bottom of the battery. The bar LED status indicators on the
LED (Figure
•
5) blinks, indicating a low-charge state. The
Figure
O
MNI
O 3600 T
MNI ERMINAL
Smart Battery
5) on the battery
3600 I G
NSTALLATION UIDE
13